RC LED Controller 3V61 - 2019
Compatible with all R/C cars and trucks . Can control 9 sets of LED lights : high beam , low beam , fog light , parking light , reverse light , brake light , turn flashing lights left and right , beacon flashing light and sound for reverse . Can switch on hazard lights ( turn on signal lights left and right at the same time ) when joystick for left and right is at one of the left or right limit for at least 10 seconds and the joystick for forward and backward is in the zero position ( middle ) , and to switch it off is the same operation .
Controller has 6 inputs from the receiver . Firs 4 of them can replace an Y servo cable , just plug a simple female to female 3 pin servo cable from receiver to controller and plug the servo in the controller .
Connectors from receiver and to servo must be plug in with the signal cable to the inside of the controller . Power supply for controller is taken from receiver via any servo cable connected strait to receiver .
Inputs to controller are being counted from right to left :
First 4 inputs are doubles and are on the same line :
ch1 - in MODE1 left/right only or in MODE2 left/right and command for R and T outputs
ch2 - forward/backward
ch3 - fog
ch4 - high beam
ch5 - beacon flashing light
ch6 - in MODE1 parking light or in MODE2 command for R and T outputs
Y - MODE set input , automatic detection depending on the type of auxiliary connected
The controller has 12 outputs for LED's with 2pin PH connectors 2mm pitch .
Each output can drive a load of 60 mA .
One output for buzzer .
Two outputs to drive the R and T auxiliary outputs , require an additional module.
Total current recommended should not exceed 800 mA for all LED outputs .
Power supply for controller should be 4.5 to 5.5 volt dc .
Dimensions 49 x 38 x 15 mm .
Controller has 6 inputs from the receiver . Firs 4 of them can replace an Y servo cable , just plug a simple female to female 3 pin servo cable from receiver to controller and plug the servo in the controller .
Connectors from receiver and to servo must be plug in with the signal cable to the inside of the controller . Power supply for controller is taken from receiver via any servo cable connected strait to receiver .
Inputs to controller are being counted from right to left :
First 4 inputs are doubles and are on the same line :
ch1 - in MODE1 left/right only or in MODE2 left/right and command for R and T outputs
ch2 - forward/backward
ch3 - fog
ch4 - high beam
ch5 - beacon flashing light
ch6 - in MODE1 parking light or in MODE2 command for R and T outputs
Y - MODE set input , automatic detection depending on the type of auxiliary connected
The controller has 12 outputs for LED's with 2pin PH connectors 2mm pitch .
Each output can drive a load of 60 mA .
One output for buzzer .
Two outputs to drive the R and T auxiliary outputs , require an additional module.
Total current recommended should not exceed 800 mA for all LED outputs .
Power supply for controller should be 4.5 to 5.5 volt dc .
Dimensions 49 x 38 x 15 mm .